- Joined
- Feb 4, 2003
- Messages
- 4,654
- Reaction score
- 4,203
- Location
- La Belle Province
- First name
- Michael
- Country
A few weeks ago, I started cutting out my Korea counters with my usual method of two Xacto knives; a large knife to cut a block out of the sheet and a small one to separate and clean up each counter. It has been awhile since I needed to cut this many counters. Last time was before I knew about the Oregon Laminations corner cutter. After doing one KFW sheet the old way, I ordered a 2mm deluxe OLCC for the half inch counters. Yesterday, I used it for the the first time. I like it. It is faster and more consistent.
Last edited: