Deluxe 2mm Corner Cutter Problem

ASLAddict

Member
Joined
Oct 16, 2018
Messages
73
Reaction score
91
Location
Saxony/Germany
Country
llGermany
Hello everybody.

I bought a second deluxe 2mm corner cutter. Unfortunately, the new 2 mm cutter does not cut well, it only slides over the counter corners when cutting.

Can I adjust the cutting surface ?

Best regards
 

Hutch

Curator of the ASL Armory
Joined
Feb 16, 2004
Messages
1,602
Reaction score
357
Location
FL
Country
llUnited States
Contact Oregon, I had one with a burr on the alignment edge. They happily repacked it after I sent it back.
 

olli

Elder Member
Joined
Jun 17, 2003
Messages
7,641
Reaction score
1,122
Location
Scotland
Country
llGermany
Hello everybody.

I bought a second deluxe 2mm corner cutter. Unfortunately, the new 2 mm cutter does not cut well, it only slides over the counter corners when cutting.

Can I adjust the cutting surface ?

Best regards
The two screws on the base plate can be loosened off and the plate pushed harder into the cutter to get a better cut you’ll need a help or somehow hold the cutting edge( lower handle) down as you push the base plate and tighten the screws again.
 

ASLAddict

Member
Joined
Oct 16, 2018
Messages
73
Reaction score
91
Location
Saxony/Germany
Country
llGermany
The two screws on the base plate can be loosened off and the plate pushed harder into the cutter to get a better cut you’ll need a help or somehow hold the cutting edge( lower handle) down as you push the base plate and tighten the screws again.
Hi Olli,

thanks for the advice.
I'll try that.

Many greetings
 
Last edited:
Top