Peter Miller
Member
Hello,
I am having LOS issues with VASL 5.5 which didn't exist for me in 5.4.3.
It works normally with the boards loaded normally but if I flip a board then it starts to have problems. Hexes that should be visable are blocked, hexes that shouldn't be seen are shown as unblocked. My first thought was that even though the board was flipped , the LOS tool was using unflipped to calculate between two hexes. With a little experimenting this doesn't seem to be the problem.
example, board 2 w4 to q1 blocked. It is from a bush hex down a straight road.
hill tops, board 2 y6 to m5 blocked. There is nothing in between.
Is any else having problems with the LOS tool.
I have tried reloading boards after setup, reinstalling boards, reinstalling 5.5 with out any success.
Any one with any other ideas that could help me.
regards
Pete
I am having LOS issues with VASL 5.5 which didn't exist for me in 5.4.3.
It works normally with the boards loaded normally but if I flip a board then it starts to have problems. Hexes that should be visable are blocked, hexes that shouldn't be seen are shown as unblocked. My first thought was that even though the board was flipped , the LOS tool was using unflipped to calculate between two hexes. With a little experimenting this doesn't seem to be the problem.
example, board 2 w4 to q1 blocked. It is from a bush hex down a straight road.
hill tops, board 2 y6 to m5 blocked. There is nothing in between.
Is any else having problems with the LOS tool.
I have tried reloading boards after setup, reinstalling boards, reinstalling 5.5 with out any success.
Any one with any other ideas that could help me.
regards
Pete